Trimble technology doubles fencers’ work capacity

Fencing contractors Barry and Heather Storch have left traditional fencing methods in dust, after using Trimble GPS technology to more than double their daily work capacity.

The pair started Storch Contracting in the year 2000, constructing predominately steel fences and stock yards for customers from North West Queensland and the Northern Territory.

Up until this year, the Storches were still using traditional fencing methods to produce their fences.
They would use their eye sight to establish a straight line for their strainer posts, and pace out the distance between their star pickets, using a top line of barb wire as a guide.

Deciding they wanted to become more efficient, the Storches purchased a Trimble Ez-Pilot Assisted Steering System and a Trimble FMX display screen from Vantage NEA and had it installed into a Polaris side by side vehicle.

Vantage NEA then developed a custom fence marking system for the Storches, by installing a spot spray tank with a solenoid attached to it, which connected to the FMX screen.

Using the GPS system, the FMX screen accurately steers the vehicle between a start and finish point while simultaneously triggering the solenoid, which sprays a line of paint on the ground every time the vehicle travels a set distance.

The paint marks represent where the star pickets need to be driven. The system also determines and marks the predetermined distance between the strainers.

The GPS position is centimetre accurate due to the use of the Trimble CenterPoint RTX positioning service, allowing the Storches to construct an extremely accurate and straight fence.

Since installing the technology, the difference in their productivity and workload has been astronomical, with Mrs Storch saying it has allowed them to double the amount of work they do in a day.

Mrs Storch said the system has removed multiple steps from the fencing process and has allowed everyone to be working at once.

Before, Mrs Storch said her, and her employees used to have to wait until Barry had marked out the fence line and assembled the posts before they were able to do anything, which would usually take most of the day.

Now, as soon as the markings are on the ground, her and her team can start rolling out wire, and driving in star pickets.

The Storches have been doing a lot of work with graziers, constructing three to four barb fences to make paddocks smaller, allowing for a stricter grazing routine.

Before they had the system, Mr Storch said he used to be able to mark out 8 kilometres of fencing in a day, he can now do that in one hour.

“We had 419 pickets assembled in a day last week, that’s 4km fencing,” Mrs Storch said.

The Storches said it was very difficult and time consuming to maintain a straight line using their original fencing methods in difficult country, that had hills or sandy soils.

Mrs Storch said it was also hard to produce a uniform product when they had to rely on their paces to make star picket markings, as every staff member would pace differently.

The system has also allowed the Storches to produce a uniform, quality product every time, regardless of the terrain they’re working on.

When we were using traditional methods, we could finish the fence and be out by more than a metre in some places,” Mr Storch said.

“Now, you come out with a dead straight line, that’s only out by between 3 to 4 centimetres.”
The Storches said investing in the Trimble equipment has been more than viable for their business.

Mr Storch said in total, installing the system cost approximately $35,000, on top of the $15,000 they invested in the side by side vehicle.

“We’ll earn that back within about three months, and it’s made us so much more efficient” he said.
The Storches said the Vantage NEA team were fantastic to work with.

“they developed a customizable system that’s greatly benefited our business,” they said.

Leave a Reply

Your email address will not be published. Required fields are marked *